Alright, your popcorn slider is made, ready
to go. But first thing we do before we give it as a gift is we need to make it pretty.
So with that stripe paper that I cut earlier, I’m just going to take a little bit of my
adhesive. And I don’t need to scour this paper. This is the simply scrap and kit paper, it’s
a little bit thinner than that textured card stock that we were using earlier. But I am
going to use my grid paper. Line this up, make sure my stripes are going even, and just
wrap it around. And on the back, again, I want to have one side that overlaps the other
evenly. And you can adjust it a little bit if you need to. There we go. So now I have
a band, belly band is what we like to call it. And now with some of these stickers that
were left over from my simply scrap and kit, because we all know we always have some left
over stickers, I’m just going to decorate this. Now this is for, let’s say a girl’s
party, so I’m going to use a lot of flowers. If it was a men’s party, I would try to find
a stamp more appropriate. I have some fishing stamps, I have a deer, I have, you know, other
variety of stamps that were more masculine. So we’re decorating this up, put a few more
stickers here. You can never have too many stickers; except for, I didn’t like that one.
And I like to layer my stickers. Because again, I like everything that comes at you that’s
3D. There you go. Friday night, next time you have a movie, make a couple of these popcorn
party slides and you guys will have a good time.